Comark N5001 Auditor General Guide Manuel d'utilisateur télécharger pdf

Comark Instruments, 52 Hurricane Way, Norwich, Norfolk NR6 6JB

T: 0844 (+44 844) 815 6599 F: 0844 (+44 844 815) 815 6598

E: salesuk@comarkltd.com

Please telephone the Comark Technical Services on 0844 815 6599

Part No 18402-2

Auditor General Use and Good Practice

The following step-by-step guide provides information on the use of the Comark Auditor. If you experience

any problem that cannot be resolved by following the steps below, please contact your local Comark Account

Manager or contact the Service Department.

1. Changing the batteries

If ‘Low Battery’ is indicated on the LCD, it is essential that the instrument be returned to the PC for

‘docking’ to download any readings. After downloading, disconnect the RS232 lead from the

instrument and undo the screw on the battery compartment. Remove the two AA cells in the battery

compartment and replace with fresh cells.

Always use alkaline, Energizer or equivalent.

Never mix old and new cells, always replace both cells at the same time. Do not mix alkaline and

rechargeable cells.

Carefully replace the battery cover to avoid damaging the seal taking care not to over tighten the

screw. If the instrument does not automatically turn on after battery change, press any button on the

keypad. The instrument will indicate that ‘docking’ is required. Reconnect the RS232 lead to ‘dock’

the instrument. After a few seconds it will show as ‘docked’ and will be ready to use again.

Change the batteries regularly, once per month if not being replaced more frequently.

2. Good practice when using the Auditor

Always download the instrument daily to the PC.

Only install and download the Auditor to one PC, never try to download the Auditor to a new PC as

records will be lost or corrupted.

Keep the instrument clean using a damp cloth with little or no detergent.

If the unit will not download then stop using it immediately and perform the checks listed below to

diagnose the problem. If this does not resolve the problem, please contact Comark for further

assistance.

3. Moving the Auditor to a new PC

Download the Auditor to the old PC, if possible.

To maintain your records, archive the database and then copy the contents to a backup device.

Install the Auditor software and then the Auditor program on a new PC.

Setup the Auditor on the PC by adding the serial number to the Auditor Group.

1 2 3

Part No 18402-2 1

Résumé du contenu

Page 1 - Part No 18402-2

Comark Instruments, 52 Hurricane Way, Norwich, Norfolk NR6 6JB T: 0844 (+44 844) 815 6599 F: 0844 (+44 844 815) 815 6598 E: [email protected] Pl

Page 2

Please telephone the Comark Technical Services on 0844 815 6599 Further information is contained in the electronic Auditor manual in the software

Page 3

Please telephone the Comark Technical Services on 0844 815 6599 8. Will not turn ON It is possible for the screen contrast to reset to zero in w

Commentaires sur ces manuels

Pas de commentaire

Comark N5001 Auditor General Guide Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Thermomètres Comark N5001 Auditor General Guide. Comark N5001 Auditor General Guide User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels